Fanuc C-Executer Operating Manual
B-62443EN-3/03E
- 881 -
FANUC Series 16/18 C Executor
4.2 Displayable characters
==========================
4.2.1 Single byte characters
(1) Displayable characters
The characters, 20-7F, A0-DF, shown in the following table can be displayed on
the screen.
| 0123456789ABCDEF
-----+-----------------
0000 |
0010 |
0020 | !"#$%&'()*+,-./
0030 | 0123456789:;<=>?
0040 | @ABCDEFGHIJKLMNO NOTE: '\' is not a BACKSLASH,
0050 | PQRSTUVWXYZ[\]^_ but a Japanese YEN mark.
0060 | `abcdefghijklmno '~' is not a TILDE mark,
0070 | pqrstuvwxyz{|}~ but a OVERBAR.
0080 |
0090 |
00A0 | xxxxxxxxxxxxxxx -+
00B0 | xxxxxxxxxxxxxxxx | This part is Japanese half-size
00C0 | xxxxxxxxxxxxxxxx | character set (KATAKANA).
00D0 | xxxxxxxxxxxxxxxx -+
00E0 |
00F0 |
(Note) Mesh mark is displayed for the character code 7F, and wave mark for A0.
Above is the code table for the standard character set. ( "ESC (4" )
(2) Control code
Following control codes are supported.
Code Symbol Function
-------+-------+-------------------------------------------------------------
08 BS Move cursor left one column.
09 TAB Move cursor to the next tab stop. (every 8 columns)
0A LF Move cursor down one line.
0D CR Move cursor to the beginning of the current line.
1B ESC Start escape sequence.
1E HOME Move cursor to the home position(upper left corner of the
screen).