
2000/02/08 H. Minami
A-78392EN
FANUC Series 16i/18i/21i-MA
Embedded macro for measurement
Title
Drawing No.
Page
Descri
tionDateEdit
31/36
4-13. 2-holes angle measurement (G192)
This is a menu for measuring an inclined angle of 2 holes center line.
Create ISO code program in the following form.
G192 Z D A B C I F ;
Z
: Height for Z axis
Input the height from the measuring start point to the point which will be measured.
D
: Hole nominal diameter
Input the nominal diameter of the holes.
A
: 1
st
measure point X
Input the approximate X coordinate of the first measuring hole center.
B
: 1
st
measure point Y
Input the approximate Y coordinate of the first measuring hole center.
C
: 2
nd
measure point X
Input the approximate X coordinate of the second measuring hole center.
I
: 2
nd
measure point Y
Input the approximate Y coordinate of the second measuring hole center.
F
: Feed rate for movement
Input the feed-rate for movement on measuring.
Note ) Please be sure to move the probe over the approximate center position of
the first measuring hole before executing this cycle.
D
1
st
Hole
(
A
,
B
)
(
C
,
I
)
X
Y
Z
Measuring
start
oint
2
nd
Hole