
7. TROUBLESHOOTING
B–63445EN/01
146
In this case, the CNC’s status display shows RESET. Refer to item 1.
(1) Only rapid traverse in positioning (G00) does not function Confirm
the following parameter and signals from the PMC.
(a) Setting value of rapid traverse rate
1420 Rapid traverse rate for each axis [mm/min]
(b) Rapid traverse override signals
#7 #6 #5 #4 #3 #2 #1 #0
G0014 ROV2 ROV1
ROV1 ROV2 Override
00
10
01
11
100%
50%
25%
Fo
1421 Rapid traverse override F0 rate [mm/min]
(2) Only feed (other than G00) does not function
(a) Maximum feed rate set by parameter is incorrect.
1422 Maximum feedrate [mm/min]
1430 Maximum feedrate in each axis [mm/min]
Feed rate is clamped at this upper feed rate.
(b) Feedrate is specified by feed per revolution (mm/rev)
1) Position coder does not rotate
Check the connection between spindle and position coder
The following failure is considered:
D Timing belt is broken
D Key is removed
D Coupling is loose
D Connector of signal cable is loosened
2) Position coder is faulty
Position coder is connected to the CNC.
For details of connection, refer to the following.
200VAC
PC
Control signal
SPINDLE (JA11)
ENC (JA12)
Position coder
Power Mate
Analog
spindle
amplifier
Spindle
motor
Spindle
i. Power Mate is in a reset
state