4. DESCRIPTION OF PARAMETERS
B–63010EN/02
328
NOTE
1 SKIPP (bit 6 of G006) and +MIT1 to –MIT2 (bits 2 to 5 of X004)
are enabled only when bit 0 (GSK) of parameter No.6200 is set
to 1 and bit 3 (MIT) of parameter No.6200 is set to 1. Note also
that these signals are enabled only for the T series.
2 The skip signals for the multistage skip function (SKIP,
SKIP2 to SKIP8) can also be disabled.
CSE For continuos high–speed skip command G31 P90, high–speed skip
signals are :
0 : Effective at either a rising or falling edge (depending on the setting of
bit 6 (SRE) of parameter 6200)
1 : Effective for both the rising and falling edges
SPE For the skip function (G31), the skip signal (bit 7 of X004) is:
0 : Disabled.
1 : Enabled.
#7
1S86202
#6
1S7
#5
1S6
#4
1S5
#3
1S4
#2
1S3
#1
1S2
#0
1S1
2S86203 2S7 2S6 2S5 2S4 2S3 2S2 2S1
3S86204 3S7 3S6 3S5 3S4 3S3 3S2 3S1
4S86205 4S7 4S6 4S5 4S4 4S3 4S2 4S1
DS86206 DS7 DS6 DS5 DS4 DS3 DS2 DS1
[Data type] Bit
1S1 to 1S8 Specify which high-speed skip signal is enabled when the G31 skip
command is issued. The bits correspond to the following signals:
1S1 HDI0
1S2 HDI1
1S3 HDI2
1S4 HDI3
1S5 HDI4
1S6 HDI5
1S7 HDI6
1S8 HDI7
1S1 to 1S8, 2S1 to 2S8, 3S1 to 3S8, 4S1 to 4S8, DS1 to DS8
Specify which skip signal is enabled when the skip command (G31, or
G31P1 to G31P4) and the dwell command (G04, G04Q1 to G04Q4) are
issued with the multi–step skip function.
The following table shows the correspondence between the bits, input
signals, and commands.
The setting of the bits have the following meaning :
0 : The skip signal corresponding to the bit is disabled.
1 : The skip signal corresponding to the bit is enabled.