4. DESCRIPTION OF PARAMETERS
B–63010EN/02
348
6511
Right margin in solid drawing
6512
Left margin in solid drawing
6513
Upper margin in solid drawing
6514
Lower margin in solid drawing
[Data type] Word
[Unit of data] Dot
These parameters set the machining profile drawing position in margins.
The unit is a dot.
Standard set value
Parameter Margin
DPO (No.6500#5)=0 DPO(No.6500#5)=1
No. area
7.2”LCD
8.4”LCD
9.5”LCD
10.4”LCD
7.2”LCD
8.4”LCD
9.5”LCD
10.4”LCD
6511 Right 0 0 200 100
6512 Left 0 0 0 0
6513 Upper 25 32 25 32
6514 Lower 0 10 0 10
DPO is set in bit 5 (DPO) of parameter No. 6500.
6515
Change in cross–section position in tri–plane drawing
[Data type] Byte
[Unit of data] Dot
[Valid data range] 0 to 10
This parameter sets the change in the cross–section position when a soft
key is continuously pressed in tri–plane drawing. When zero is specified,
it is set to 1.
6520
C–axis number for dynamic graphic display
[Data type] Byte
[Valid data range] 0, 1 to number of controlled axes
This parameter sets a C–axis number for dynamic graphic display. When
0 or a value greater than the number of controlled axes is specified with
this parameter, the third axis is assumed.