2.FOR Series 15-B OPERATION
B62694ENlQa
2.1.1 Notice when You Use for the First Time
I
WARNING
If you use this function for the first time, you must initiate
the HDD according to “2.8.2 Formatting the Built-in Hard
Disk” and input the setting data according to “2.2 SETTING
SCREEN”. And turn off and then turn on the power of the
CNC.
If you use this function before you operate these, we don’t
guarantee that this function operates normally.
About FTP on the Ethernet, when you use this function for
the first time, please set Ethernet addresses carefully and
check this function on your environment according to your
network administrator’s advice.
If you set wrong Ethernet addresses, it may make a heavy
effect on your network.
CAUTION
1 If you turn off the power during reading the data from the
HDD or writing to the HDD, it may make the registered file
in the HDD broken.
So, you must not turn off the power during executing the
Data Server functions.
2 Be sure to take the backup of the data in the HDD against
an emergency.
- 112-