
20. FUNCTIONS FOR HIGH SPEED
CUTTING
B–64112EN/01
NC FUNCTION
204
This function is designed for high–speed precise machining. With this
function, the delay due to acceleration/deceleration and the delay in the
servo system which increase as the feedrate becomes higher can be
suppressed.
The tool can then follow specified values accurately and errors in the
machining profile can be reduced.
This function becomes effective when advanced preview control mode is
entered.
G08 P_ ;
P1 : Turn on advanced preview control mode.
P0 : Turn off advanced preview control mode.
In advanced preview control mode, the following functions are available :
D Linear acceleration/deceleration before interpolation
D Automatic corner deceleration function
By taking full advantage of high–precision contour control using a RISC
processor, this function enables high–speed high–precision machining
without the need for special hardware.
The function enables look–ahead linear acceleration/deceleration before
interpolation of up to 15 blocks. This results in smooth acceleration/
deceleration over many blocks, as well as high–speed machining.
G05.1 Q_ ;
Q1 :
Q0 :
G05.1
Start AI advanced preview control mode
End AI advanced preview control mode
A block for specifying G05.1 must not contain any other
command.
AI advanced preview control mode can also be canceled
by a reset.
T series
20.1
ADVANCED PREVIEW
CONTROL (G08)
Format
20.2
AI ADVANCED
PREVIEW CONTROL
(G05.1) (M series)
M series
Format