Manual Guide M Advanced Programming
GE Fanuc Automation S.A. - 122
-
GFKE-0046-EN/01
8
ADVANCED PROGRAMMING
8. 1 Finish / Chamfer / Pre-Hole
In milling menus are finishing, chamfering and pre-
hole drilling processes available.
•
FACING face finish
•
SIDE Square bottom / side finish, chamfer
SIDE Circle
SIDE Track
SIDE One Side
SIDE Contour no chamfer
•
POCKET Square bottom / side, chamfer, hole
POCKET Circle
POCKET Track
POCKET Groove bottom / side, chamfer
POCKET Contour bottom / side, hole
POCKET C-Groove bottom / side, hole
Finishing with the same Tool
Finishing can be performed with the same tool or a
different tool. If the same tool and the same cutting
condition will be used for finishing, only machining
process itself has to be called again, to enter data for
finishing.
Finishing with other Tool
Finishing can be performed with other tool and
different cutting condition. In this case, data for tool
preparation spindle speed and tool length
compensation has to be performed before in menu
TOOL, MSF and COMP. Then the machining
process itself has to be called again, to enter specific
data for finishing.
Chamfer / Pre-Hole drilling
In case of Chamfer and Pre-Hole drilling, please see
paragraph before, Finishing with other tool.
Important note
In case that FINISHING is necessary, make sure, that in
ROUGHING process the finishing amount is input.