Manual Guide M Details of Menu
GE Fanuc Automation S.A. - 28 -
GFKE-0046-EN/01
2. 8. 6 End
The End Soft-Key is used, when the contour or a
certain part of the figure input should be finished.
After pushing the Soft-Key " END ", the following
pop-up window is displayed:
There are two possibilities to use the END-Menu.
To select one of them, following Soft-Key's are
available:
END
Contour data input is finished. Even if the figure will
be continued, first 'End' must be input!
CONT
Contour data input can be continued,
select a new start to define:
Island or other Next Movement (Next Figure)
After all data input, push "INSERT" key. Then the
pop-up window is closed and the entered data are
displayed in the Program Window.
Input Data Input Pop-Up Menu
Can be selected by Detail Menu
G106 P… ;
G106 = G-Code for Contour End
P = 1 Contour End
= 2 Contour continue