B-65382EN/02 PREFACE
p-3
ACCEPTANCE AND STORAGE
WARNING
Mishandling a magnet plate may be highly
dangerous, resulting in a fatal accident. Read and
thoroughly understand the cautions on the next
page and Part III, "HANDLING, DESIGN, AND
ASSEMBLY," before handling the magnet plate
and strictly observe the cautions when handling it.
Do not handle the magnet plate unless you have
been trained in handling linear motors.
A "motor" described in this manual means all parts
of the linear motor: Coil slider, magnet plate,
magnetic pole sensor, cooling plate, and others.
After you have received a FANUC Linear Motor, check it as follows:
• Is the linear motor exactly what you ordered? Check the motor
model, magnet plate, and sensor.
• Is it free from any damage? Damage may have occurred during
shipment.
• Are all accessories supplied with the linear motor?
All models of coil sliders are supplied with a nameplate and
laminate sheet. Terminal models of coil sliders are supplied
with a crimp terminal, rubber dripproof terminal cover, and
thermostat connector.
All FANUC Linear Motors are strictly inspected and carefully packed
before shipment. They need no special incoming inspection. Just
check the specifications (for wiring, current, voltage, and other data)
of the motor as required. When measuring resistance and insulation
data, reference Part V, "MAINTENANCE." Be extremely careful in
measuring the dimensions of the magnet plate as incoming inspection
because the plate has very strong magnetism.
• Do not apply unnecessary external force or shock to the motor.
Otherwise, the motor may be damaged and become incapable of
operating normally.
• Do not machine the motor without permission. If the motor
requires machining, machine only the portion specified or
approved by FANUC.
• Keep the motor from contact with and away from water and oil,
chemicals which may damage motors, conductive materials, and
other materials harmful to motors.
• Store the motor in indoor locations where are free from rainwater,
condensation, and excessive dust. Avoid warming or cooling the
motor externally when unnecessary and placing it in special
environments.