
2 CNC Backup Procedure
The FANUC / GE Fanuc CNC comes with an own Boot Menu, which makes it easy to save or load
system data, setting data and application programs.
Two different procedures dependent on the CNC configuration must be considered.
1. The CNC is connected to a LCD-Display only
The name of the CNC series is 16i/18i /21i Model B
2. The CNC is connected over H
igh Speed Serial Bus (HSSB) to Panel i.
The name of the CNC series is 160i/180i /210i Model B
However, the CNC data to be saved are the same for both configurations. Also the procedure is
similar and follows a common philosophy.
File Name: Backup_Guidance_EN21.doc
Created by: Olaf Sklepik on 20-Apr-05
Approved by: n/a
Page 8 of 72