
9. FANUC INTELLIGENT TERMINAL
B–63323EN/03
340
Optical link module cable
AMP (dynamic)
AMP (mini DIN 6–pin cable)
Honda (PCR 20–pin cable)
Hirose Denki (34–pin flat cable)
Hirose Denki (40–pin flat cable)
AMP (EI series 4–pin cable)
Molex (5046–NA 3–pin cable)
Other
MMX–Pentium
intelligent terminal
CNC control unit
Power unit
HSSB interface board
HSSB(COP7)
Another printed circuit
board
MDI(JA2)
Power (+24VDC)
3.5” HDD unit
FAN unit
Full keyboard
Mouse
I/O device
I/O device
Printer
Power
Power
Power
PCMCIA
card
ISA
expansion
backplane
ISA expansion
board
ISA expansion
board
Floppy
disk drive
ISA expansion
*1 Can be used only during application development. Cannot be incorporated into the system.
*1 For an explanation of the connection of the devices other than those shown above, see the connection manual supplied with the CNC.
*2 Install the FAN–unit–attached HDD unit at the rear of the MDI.
Separate MDI
PCMCIA card slot
10.4” or 12.1” color LCD panel
RS232–C channel 1
RS232–C channel 2
For an explanation of the connection of the devices other than those
shown above, see the connection manual supplied with the CNC.
9.4.2
If the Soft Keys are
Attached But the Touch
Panel is Not Attached