
B–63323EN/03
10. FANUC PANEL i
367
– The copyright of Windows 2000, Windows NT, Windows 95/98 and
other software provided with the PANEL i is owned by Microsoft
Corporation (USA), NeoMagic Inc., Phoenix Technologies Ltd.,
PFU Co.,Ltd, and FANUC LTD.
– No part of the software described above, or its manuals, may be used
or reproduced without permission.
– No part of the software described above, or its manuals, may be sold
independently of the PANEL i.
– The software described above, and its manual, must be used under the
conditions described in the attached license agreement.
– The use of the CNC incorporating the Intelligent Terminal 3 shall
imply that the user agrees to the conditions of the license agreement
described above.
*Windows2000, Windows NT and Windows 95/98 is a registered
trademark of Microsoft corporation, USA
*Company name and product name mentions in this manual are
(registered) trademark of each company.
CAUTION
1 If an operation error or mishap occurs, the data on the hard
disk may be lost, even if all the installation conditions are
satisfied. Therefore, always maintain a backup copy of the
data on the hard disk in case the stored data is lost or
damaged.
Especially, the power–off on accessing the hard disk must
not be done because that possibility is very high. Please
concern for the end–users.
2 Be sure to finish the OS and the applications through the
proper operation of shutdown before turning the power off.
Without the above–mentioned operation, there is no
assurance of the following action. At worst, the command of
initializing the HDD will not work.
10.2
ATTENTION