
D. OPTICAL FIBER CABLE
B–63323EN/03
498
(b)Example of the use of an optical fiber adapter
Optical fiber cable
with low–loss optical
junction
Optical fiber adapter with low–loss optical junction
(A63L–0020–0002)
Optical fiber cable with low–loss
optical junction
Mounting board
NOTE
Up to one relay points are permitte.
7. Precautions for connection with low–loss optical junction adapter
D Features of and handling precautions for low–loss optical junction
adapter (A63L–0020–0004)
When optical connectors for a conventional optical junction
adapter (A63L–0020–0002) are jointed, the facing ferrules(Note 1)
are located about 60 um from each other. This is because the optical
fiber of conventional PCF (plastic clad silica fiber) cables
(A66L–6001–0008, –0009, –0026) may protrude from the tip of
the ferrules (by up to about several um), resulting in the fiber
protrusion being damaged when the ferrules are butted against each
other.
In the low–loss optical junction adapter, the ferrules are butted
against each other, thus greatly reducing the reduction in repeater
loss. Therefore, the two optical cables used with the low–loss
optical junction adapters must be dedicated to the adapters.
If a conventional PCF (plastic clad silica fiber) cable
(A66L–6001–0008, –0009, –0026) is used as even one of the two
optical fiber cables for joining the low–loss optical junction
adapter, both cables may be damaged, resulting in deteriorated
characteristics.
NOTE
Ferrule: Movable metal at the tip of an optical connector; the
fiber is bonded to the ferrule.