
B–63323EN/03
9. FANUC INTELLIGENT TERMINAL
343
CAUTION
Even in an environment that satisfies the conditions
described above, the data stored on the hard disk may be
damaged because of an operational mistake or inadvertent
accident.
Never turn off the power while the hard disk is being
accessed because this increases the possibility of damage.
Warn the end user about this hazard.
Just in case, be sure to back up the important data on the
hard disk.
Development and maintenance options may fail to satisfy the above
environment conditions.
(1) Input power
(a) Specifications
The power supply used with the intelligent terminal must satisfy
the following specifications:
Input power voltage +24VDC"10%
Current capacity 4A max.
* If FANUC devices such as the Handy File are connected to the
RS–232–C port for use, another 1A is required.
(b)Timing
The intelligent terminal may be turned on either before and after the
CNC is turned on.
Note that, however, when the CNC is turned on solely without
turning on the intelligent terminal, the CNC does not start
normally. In addition, while the intelligent terminal is kept on, you
cannot turn the CNC off and on.
(2) Supply of power
The intelligent terminal can supply power to peripheral devices as
follows. Check the current requirement of each peripheral device to
be used.
Power voltage Peripheral device Current (max.)
+12V ISA and PCMCIA cards 400mA
+5V
FDD (CN2), PCMCIA card,
keyboard (JD33, CD32A), mouse (JD33,
CD32B)
1000mA
ISA 3500mA
–5V ISA 74mA
–12V ISA 180mA
9.5.2
Power Specifications