
B–63323EN/03
9. FANUC INTELLIGENT TERMINAL
361
(1) Available board
The ISA expansion board shown below is available to the intelligent
terminal. Up to two boards can be installed.
Parts height at the rear: 3.81 mm or less
Parts height at the front: 13.34 mm or less
Portions supported by the vibration–proof brackets
170 mm or less
55
20 20
In mm
79 mm to 113 mm
(If the depth is out of
the above range, the
board cannot be
supported by the
vibration–proof
brackets.)
(2) Procedure for installing the ISA expansion board
(See the figure on the next page.)
1) Remove the vibration–proof brackets.
2) Insert the board firmly into the connector as far as it can go.
3) Fasten the board with the screws at the screw fastening portions.
4) Fasten the vibration–proof brackets with the screws, while
pressing the brackets against the board.
If two ISA expansion boards are to be installed, the two boards cannot
be supported by the vibration–proof brackets if the height of the board
to be inserted into slot A is greater than that of the board to be inserted
into slot B.
9.8
ISA EXPANSION
BOARD
9.8.1
Installation Procedure