
18. SPINDLE FUNCTIONS
B–63443EN/02
PMC INTERFACE
194
The S command specifies the spindle speed entered from machining
programs, etc. for the CNC.
For constant surface speed control (during G96 mode), the CNC converts
the specified surface speed to the spindle speed.
With the spindle analog module, the spindle control function in the CNC
converts the S command value to the output value for the spindle motor.
For correspondence to gear change and constant surface speed control, the
S code/SF signals output is different as follows in case of the spindle
analog module is not used.
Outputs neither S code nor SF signal.
(This is because the S code is not always the spindle speed when the
constant surface speed control option is used.)
If you use the S code for processing in the PMC ladder, you must specify
parameters related to parameter No. 3705.
This signal sets the S command value in the CNC to 0. This signal sets
the speed command for the spindle to 0.
Even if the function of the spindle stop signal is not used, the signal must
be set to logical 1 for the CNC to perform spindle speed control.
If the spindle orientation signal is logical 1 and the spindle stop signal is
logical 0, the spindle rotates in the direction specified by bit 5 (ORM) of
parameter No. 3706 at a constant speed specified by parameter No. 3732.
Because the spindle rotates at a constant speed regardless of the gear
stage, this signal can be used to rotate the spindle to drive the stopper or
pin during mechanical spindle positioning.
This signal specifies an override of 0% to 254% for the specified S value
for spindle control.
However, the spindle speed override function is disabled when the CNC
is in the thread cutting (G32)
When the spindle speed control is performed but the spindle speed
override is not used, set the override value to 100%.
Although the S command contains the spindle speed, the object that is
actually controlled is the spindle motor. Therefore, the CNC must have
some provision to detect the gear stage between the speed and spindle
motor.
The gear stage (one of the four gear stages ) being currently used by the
machine is input in response to the gear select signal inputs (GR1, GR2).
The machine determines which gear to use.
The CNC outputs the spindle speed that corresponds to the gear stage
input.
D S command
D S code/SF signal output
D Spindle stop signal
(*SSTP)
D Spindle orientation
signal (SOR)
D Spindle speed override
signal (SOV00 to SOV07)
D Processing for gear
changing