
B–63443EN/02
7. CONNECTION TO CNC PERIPHERALS
HARDWARE
87
(2) RS–232–C interface signals
Signal name
RS–232–C
circuit number
Input/output Description
SD 103 Output Send data
Start bit
Stop bit
RD 104 Input Receive data
12345678
ON
OFF
(The ISO code for 0 is sent)
RS 105 Output Request to send
This signal is turned on when data output from the NC machine is started; it
is turned off when data output from the NC machine is terminated.
CS 106 Input Ready for sending
When this signal and the DR signal are on, data can be output from the NC
machine. If the I/O device is not ready in time, for example, for punch–out
operation, this signal, when turned off, causes the NC machine to stop data
transmission after sending a maximum of two characters including charac-
ters currently being transmitted. When this signal is not used, be sure to con-
nect this signal to the RS signal on the NC.
DR 107 Input Data set ready
When this signal is no, the I/O device is ready. Generally, this signal is con-
nected with a signal for indicating the power–on state(*1) of the I/O device
(ER signal on the I/O device side). The NC sends data when this signal is
on. If this signal is turned off during data transmission, alarm No.086 occurs.
When this signal is not used, be sure to connect this signal to the ER signal
on the NC.
ER 108.2 Output NC equipment ready
When this signal is on, the NC machine is ready for operation. An I/O device
regards the SD signal sent while the ER signal is on, as valid information.
CD 109 Input Signal quality detect
This signal is not used for connection with an I/O device. Be sure to connect
this signal with the ER signal on the NC in the cable.
SG 102 Signal ground
FG 101 Frame ground
–3V or lower +3V or higher
Function OFF ON
Signal Condition Marking Spacing
(3) RS–232–C interface transmission system
(a) Start–stop system
In general, two systems can be used for serial interface
transmission: the start–stop system and synchronous system.
With Power Mate the start–stop system is used.
Start–stop system: Information bits are transmitted preceded by
a start signal and followed by a stop signal.
NOTE
The signal is turned on and off as follows: