PROGRAMMING7. COORDINATE SYSTEM
B–64124EN/01
94
When an absolute workpiece zero point offset value is specified, the
specified value becomes a new offset value. When an incremental
workpiece zero point offset value is specified, the specified value is added
to the current offset value to produce a new offset value.
A P code must be specified after G54.1 (G54). If G54.1 is not followed
by a P code in the same block, additional workpiece coordinate system
1 (G54.1P1) is assumed.
If a value not within the specifiable range is specified in a P code, an P/S
alarm ( No. 030) is issued.
P codes other than workpiece offset numbers cannot be specified in a
G54.1 (G54) block.
Example) G54.1 (G54) G04 P1000 ;
D Setting the workpiece
zero point offset value in
the additional workpiece
coordinate systems
Limitations
D Specifying P codes