
4.PARAMETER SETTING START-UP B-65222EN/03
- 154 -
4.1 LINEAR MOTOR PARAMETER SETTING
4.1.1 Procedure for Setting the Initial Parameters of Linear Motors
(1) Overview
The following describes the procedure for setting the digital servo
parameters to enable the use of a FANUC linear motor.
(2) Series and editions of applicable servo software
Series 9096/A(01) and subsequent editions (Series 21i, Power Mate i)
Series 90B0/A(01) and subsequent editions (Series 15i, 16i, 18i, 21i )
(3) Setting parameters
The position and velocity of the linear motor are detected using a
linear encoder. Two types of linear encoders are available:
incremental type and absolute type. The parameter setting and
connection vary according to the type of encoder.
Incremental type
The linear encoder of incremental type is connected to a servo
amplifier via a position detection circuit (A860-0333-T001, A860-
0333-T002) manufactured by FANUC. Depending on the signal pitch
(resolution) of an encoder connected, the parameter setting varies.
First, check the signal pitch. Table lists examples in the II-1.1.2 of
incremental type linear encoders currently usable.
Absolute type
The linear encoder of absolute type is directly connected to a servo
amplifier. Depending on the resolution of an encoder used, the
parameter setting varies. First, check the resolution. Table lists
examples in the II-1.1.2 of absolute type linear encoders currently
usable.