
TITLE
B-63173EN-1/02
EDIT
DATE DESIG. DESCRIPTION
ower
ate i-
The function that key matrix of MDI can be changed
from M-type to T-type
Connection manual (function)
DRAW.NO. CUST.
SHEET
01
990624 New design
13
Add following description after “12.1.12 Periodic Maintenance Screen”.
12.1.13
Switching Key Codes
General
Key codes(M or T) can be switched to fit the key code of CRT/MDI by parameter. When
CRT/MDI is used commonly by Power Mate i and another kinds of CNC,
MDI key can be continued to be used.
(example for common use of CRT/MDI)
Note. As the hardware interface is different between Power Mate
and the other CNC such as FS18i-TA, the signal
converting circuit is required to share CRT/MDI unit.
Parameter
#7 #6 #5 #4 #3 #2 #1 #0
3119 TKEY
【Data type】Bit type
TKEY Using MDI key code is
0 : M type
1 : T type
Note
After setting this parameter, turn the power off then on again so that the setting
will take effect.
CRT/MD
FS1
-T
Power Mate