B–63835EN/03
2. HARDWARE
187
(1)Remove the terminal block from the connector on the DeviceNet
board. The terminal block can be pulled out after the screws on both
sides are loosened. The terminal block can be removed with cables
connected.
Screw
(2)Remove the main CPU board. The main CPU board can be removed
after the terminal block of the DeviceNet connector is removed.
(3)Hold handles C and D of the DeviceNet board. Pushing the latch of
handle C to the right, pull out the board.
NOTE
The DeviceNet board can be removed after the main CPU
board is removed. If an attempt is made to pull out the
DeviceNet board without removing the main CPU board, the
printed board may be damaged.
(1)Before mounting the DeviceNet board, remove the main CPU board.
NOTE
The DeviceNet board can be mounted after the main CPU
board is removed. If an attempt is made to mount the
DeviceNet board without removing the main CPU board, the
printed circuit may be damaged.
(2)Remove the terminal block from the connector on the DeviceNet
board. (See the removal procedure described above.)
(3)Mount the DeviceNet board in the cabinet without the main CPU
board. Holding handles C and D, insert the board into the cabinet until
the connector on the back panel is connected.
(4)After mounting the DeviceNet board, mount the main CPU board.
(5)Mount the terminal block removed in (2) to the connector. Securely
tighten the screws.
2.6.3
Mounting and
Removing the
DeviceNet Board
2.6.3.1
Removing the board
2.6.3.2
Mounting the board