
09 00.11.21 K.Yamamuro Revised to edition 09
08 00.06.22 T.Watanabe Revised to edition 08 T.Endo
01 99.03.10 K.Yamamuro New-registered T.Endo
A-63537E
ED DATE DESIG.
DESCRIPTION 99/134
SHEET
TITLE
FANUC Series 16i/18 i -TA
Compound Machining Function
TITLE
CUST.DRAW.NO.
6 Additional alarms
The following signals have been added for the function.
5253 T/M MODE CAN NOT BE SWITCHED
Turning/milling modes cannot be changed in spite of commanding M code for
it.
The followings are possible causes.
- The M code is not commanded alone.
- Modal G codes are not cancelled at the M code commanding.
- The M code is commanded from called sub program or macro program.
213 ILLEGAL COMMAND IN SYNCHRO-MODE
The relation of coordinate systems between turning and milling modes are
no longer correct.
5309 IMPROPER ?????
In turning mode, the offset can be specified only with B-90, B00, and B90