
B–63505EN/02
2. HARDWARE
107
This section describes the location and replacement of the LCD fuse.
WARNING
Before replacing a blown fuse, it is necessary to remove the
cause of the blown fuse. For this reason, only the personnel
who have a working knowledge of maintenance and safety
are allowed to carry out this work. When replacing a fuse
with the cabinet open, be careful not to touch the
high–voltage circuit section (marked and shielded with
a shock hazard prevention cover). If you touch the
high–voltage circuit section when it is uncovered, you will
get an electric shock.
Fuse FS1
LCD Unit (Rear view)
(1) If the fuse blows, first find and eliminate the cause. Then, replace the
fuse.
(2) Pull the old fuse up.
(3) Push a new fuse into the fuse holder.
Ordering code : A02B–0200–K103 *
Rating : 5.0 A
*In–house code : A60L–0001–0290#LM50
2.5.2
Replacing the Fuse for
LCD
D Location of the LCD fuse
D Replacing the fuse
D Ordering information