
1. DISPLAY AND OPERATION
B–63505EN/02
34
To select a particular bit, position the cursor to that bit by pressing the
cursor key or , then press the [ON:1] soft key. To cancel
a selection made by pressing the [ON:1] soft key or to cancel a
previously selected signal, press the [OFF:0] soft key.
(5)Up to 20 addresses can be specified by means of this signal selection.
These addresses need not always be specified at consecutive positions,
starting from No.1.
(6)Pressing the [ALLDEL] and [EXEC] soft keys deletes all data. If the
[ALLDEL] key is pressed by mistake, it can be cancelled by pressing
the [CAN] key.
(7)To delete a selected signal address, position the cursor to the
corresponding position then press the [DELETE] and [EXEC] soft
keys. In the SIGNAL column, asterisks ******** are displayed in
place of the deleted data. In the ADDRES column, the corresponding
position is cleared.
If the [DELET] key is pressed by mistake, it can be cancelled by
pressing the [CAN] key.
(8)Pressing the return menu key
causes the [OPEHIS] (OPE) soft
key to be displayed again.
NOTE
1 A cross (×) indicates that a signal will not be recorded. Also,
any signal for which an address is not specified will not be
recorded, either.
2 A circle (f) indicates that a signal can be recorded.
3 A signal indicated by its symbol name will also be displayed
by its symbol name.
1. M/T addresses
MT→PMC
#7
fX000
#6
f
#5
f
#4
f
#3
f
#2
f
#1
f
#0
f
fX127 f f f f f f f
to
fX1000 f f f f f f f
fX1011 f f f f f f f
to
PMC→CNC
#7
fG000
#6
f
#5
f
#4
f
#3
f
#2
f
#1
f
#0
f
fG003 f f f f f f f
fG004 f f f FIN f f f
fG005 f f f TFIN SFIN f MFIN
to
D Input signals and output
signals to be recorded in
the history