
3. DATA INPUT/OUTPUT
B–63785EN/01
254
(1)Enter EDIT mode.
(2)Follow either of the procedures described below to display the
maintenance information screen:
Method 1
(1)Press the
SYSTEM
function key several times, until the
maintenance information screen appears.
(2)If the screen is in Japanese display mode, change the input mode
to single–byte alphanumeric mode.
Method 2
(1)Press the
SYSTEM
function key.
(2)Click the [MAINTEINFO] soft key.
(3) If the screen is in Japanese display mode, change the input
mode to single–byte alphanumeric mode.
Method 1 (neither the output file name nor number need be specified)
(1)Click the [PUNCH] soft key.
(2)Click the [MAINTEINFO] soft key.
Method 2 (the output file name is specified)
(1)Click the [PUNCH] soft key.
(2)Click the [”FILE NAME] soft key.
(3)Key in the file name.
(4)Click the [FILE NAME”] soft key.
(5)Click the [MAINTEINFO] soft key.
Method 3 (the file number is specified, one of three methods)
(1)Click the [PUNCH] soft key.
(2)Click the [(FILE#)] soft key.
(3)Key in the file number.
(4)Click the [MAINTEINFO] soft key.
Method 4 (the file number is specified, one of three methods)
(1)Click the [PUNCH] soft key.
(2)Click the
N
address key.
(3)Key in the file number.
(4)Click the [MAINTEINFO] soft key.
Method 5 (the file number is specified, one of three methods)
(1)Click the
N
address key.
(2)Key in the file number.
(3)Click the [PUNCH] soft key.
3.2.13
Output of Maintenance
Information
Setup for output
Executing output