
APPENDIX
B–63785EN/01
B. ALARM LIST
471
Number Message Contents
SR0125 ILLEGAL EXPRESSION FORMAT The description of the custom macro statement is erroneous.
The format of the parameter data is erroneous.
SR0160 COMMAND DATA OVERFLOW An overflow in the CNC internal positional data occurred.
This error is also generated when the target position exceeds the
maximum stroke as a result of calculating coordinate conversion, offset
and manual intervention compensation inputs.
SR0421 SETTING COMMAND ERROR The specified tool data setting (G10 L70 to G11, G10 L71 to G11) is
erroneous.
SR0422 NOT FOUND TOOL DATA The tool No. (pot No. ) to which tool data delete was specified cannot be
found.
SR0423 TOOL DATA WRITE ERROR A write error occurred simultaneously on tool offset data by a tool No.
SR0424 OVER MAXIMUM TOOL DATA An attempt was made to set tool data that exceeds the maximum
number of tool data sets.
SR0425 NOT DELETE TOOL DATA IN OPERATION An attempt was made to delete currently selected tool data.
SR0580 ENCODE ALARM (PSWD&KEY) When an attempt was made to read a program, the specified password
did not match the password on the tape and the password on tape was
not equal to 0.
When an attempt was made to punch an encrypted tape, the password
was not in the range 0 to 99999999.
The password parameter is No. 2210.
SR0581 ENCODE ALARM (PARAMETER) When an attempt was made to punch an encrypted tape, the punch
code parameter was set to EIA. Set EIA parameter No. 0#4 to “0”.
An incorrect instruction was specified for program encryption or
protection. This alarm is also generated when the protected range is
edited or deleted in a program–locked state.
The protected range is defined from the program No. preset by
parameter No. 2212 up to the program No. preset to parameter No.
2213. When both parameters are set to “0”, the protected range
becomes O9000 to O9999.
SR0590 TH ERROR A TH error was detected during reading from an input device.
The read code that caused the TH error and how many statements it is
from the block can be verified in the diagnostics screen.
SR0591 TV ERROR An error was detected during the single–block TV error.
The TV check can be suppressed by setting TVC parameter No. 0000#0
to “0”.
SR0592 END OF RECORD The EOR (End of Record) code is specified in the middle of a block.
This alarm is also generated when the percentage at the end of the NC
program is read.
This alarm is also generated when the specified block is not found by
the program restart function.
SR0600 PARAMETER OF RESTART ERROR An illegal value is set to parameter No. 7110 that specifies the order in
which axes move when machining is restarted in the dry run.
The setting range is 1 to the number of controlled axes.
SR0805 ILLEGAL COMMAND An attempt was made to specify an illegal command during I/O
processing on an I/O device.
SR0806 DEVICE TYPE MISS MATCH An operation not possible on the I/O device that is currently selected in
the setting was specified.
This alarm is also generated when file rewind is instructed even though
the I/O device is not a FANUC Cassette.
B.3
SR ALARM