
B–63785EN/01
7.TROUBLESHOOTING
419
WARNING
Only those personnel who have received approved safety
and maintenance training may perform this replacement.
Before opening the cabinet and replacing a board, turn off
both the power to the CNC unit and the main power to the
power magnetics cabinet. If only the power to the CNC unit
is turned off, the power to the servo may remain on, possibly
damaging boards and peripheral units and presenting a
danger of electric shock.
CAUTION
When removing a printed circuit board, note the following:
(a)Avoid touching the semiconductors and other parts on the
board.
(b)Removing the power supply unit or main board (together
with cards and modules) may cause the contents
(parameters and programs) of CNC CMOS memory to be
lost. Always make a backup to media such as memory
cards or floppy disks before attempting such an operation.
(c)Disconnected cables must be reconnected to their original
locations. If there is a chance of forgethering how the cables
are connected, make a note before disconnecting them.
7.16
HOW TO REPLACE
THE FUSES IN EACH
UNIT