
APPENDIX
B–63785EN/01
A. BOOT SYSTEM
431
(1)
(2)
(3)
(4)
(5)
(6)
(7)
RAM TEST : END
ROM TEST : END xxxx x (ERROR)
DRAM ID : xxxxxxxx
SRAM ID : xxxxxxxx
FROM ID : xxxxxxxx
CNC DATA SEARCH : END (ERROR)
*** MESSAGE ***
LOADING CNC DATA xxxxxxxx/xxxxxxxx
END
If an error occurs, the system stops.
RESET key→SYSTEM MONITOR
(1)Displays the results of a WORK RAM test. If an error occurs, the
results cannot be displayed. The error is not displayed here, but on the
LED display. (See “LED display.”)
(2)Displays the results of a BOOT ROM parity test. If no error occurs,
the series/version are displayed. If an error occurs, the system stops.
(3)Displays the ID of the DRAM MODULE mounted on the CNC.
(4)Displays the ID of the SRAM MODULE mounted on the CNC.
(5)Displays the ID of the FROM MODULE mounted on the CNC.
(6)The validity of the CNC BASIC software in flash memory is checked.
This check is performed based on data identification information only.
The parity check is performed when the CNC is turned on.
If an error occurs, pressing the
RESET
key causes the SYSTEM
MONITOR screen to be selected.
(7)Indicates that the CNC BASIC software is being loaded from flash
memory into DRAM.
A.1.1
Power–on Sequence
Display
D Details of the display
items