
APPENDIXB. ALARM LIST
B–63785EN/01
478
Number ContentsMessage
SV0128 ABNORMAL TORQUE (4TH SPDL) An abnormal load was detected at the No. 24 spindle motor. This alarm
is canceled by resetting the control.
SV0350 EXCESSIVE TORQUE DIFFERENCE In synchronization control, the values specified by the torque commands
for the master and slave axes exceeded the value set in parameter No.
1716.
This alarm is generated only for the master axis.
SV0360 ABNORMAL CHECKSUM (INT) The checksum alarm occurred on the built–in pulse coder.
SV0361 ABNORMAL PHASE DATA (INT) The phase data abnormal alarm occurred on the built–in pulse coder.
SV0363 ABNORMAL CLOCK (INT) The clock alarm occurred on the built–in pulse coder.
SV0364 SOFT PHASE ALARM (INT) The digital servo software detected abnormal data on the built–in pulse
coder.
SV0365 BROKEN LED (INT) Abnormal LED on the built–in pulse coder
SV0366 PULSE MISS (INT) A pulse error occurred on the built–in pulse coder.
SV0367 COUNT MISS (INT) A count error occurred on the built–in pulse coder.
SV0368 SERIAL DATA ERROR (INT) The communications data could not be received from the built–in pulse
coder.
SV0369 DATA TRANS. ERROR (INT) A CRC error or stop bit error occurred in the communications data from
the built–in pulse coder.
SV0380 BROKEN LED (EXT) Standalone detector error
SV0381 ABNORMAL PHASE (EXT LIN) An abnormal alarm in the position data occurred on the standalone linear
scale.
SV0382 COUNT MISS (EXT) A count error occurred on the standalone detector.
SV0383 PULSE MISS (EXT) A pulse error occurred on the standalone detector.
SV0384 SOFT PHASE ALARM (EXT) The digital servo software detected abnormal data on the standalone
detector.
SV0385 SERIAL DATA ERROR (EXT) The communications data could not be received from the standalone
detector.
SV0386 DATA TRANS. ERROR (EXT) A CRC error or stop bit error occurred in the communications data from
the standalone detector.
SV0409 DETECT ABNORMAL TORQUE An abnormal load was detected on the servo motor, or during Cs axis or
spindle positioning.
SV0421 EXCESS ERROR (SEMI–FULL) The difference between the feedback from the semi and full sides
exceeded the setting of parameter No.1729.
SV0430 SV MOTOR OVERHEAT The servo motor has overheated.
SV0431 CNV. OVERLOAD PSM: Overheat
B series SVU: Overheat
SV0432 CNV. LOWVOLT CONTROL PSM: The control power supply voltage has dropped.
PSMR: The control power supply voltage has dropped.
β SVU: The control power supply voltage has dropped.
SV0433 CNV. LOW VOLT DC LINK PSM: Missing phase in input voltage
PSMR: Low DC link voltage
A series SVU: Low DC link voltage
B series SVU: Low DC link voltage