
APPENDIX
B–63785EN/01
B. ALARM LIST
459
Number ContentsMessage
PS0281 OVER TOLERANCE OF END POINT IN
SPIRAL
The distance between the positions of the specified end point and the
end point calculated from the programmed block exceeds the value set
to parameter No. 2511.
Either change the end point to be specified, or set a larger value to
parameter No. 2511.
PS0282 ILLEGAL COMMAND IN 3–D OFFSET An illegal G code was specified in the 3–dimensional tool offset mode.
PS0283 ILLEGAL IJK IN 3–D OFFSET When bit 0 (ONI) of parameter No. 6029 is set to 1, I, J, and K com-
mands are specified without the decimal point in three–dimensional tool
compensation mode.
PS0298 ILLEGAL INCH/METRIC CONVERSION An error occurred during inch/metric switching.
PS0299 ILLEGAL ZERO RETURN COMMAND A value other than 2 to 4 was specified to address P in the No. 2 to No.
4 zero return instruction.
PS0300 ILLEGAL ADDRESS The axis No. address was specified even though the parameter is not an
axis–type while loading parameters or pitch error compensation data
from a tape or by entry of the G10 parameter.
Axis No. cannot be specified in pitch error compensation data.
PS0301 MISSING ADDRESS The axis No. was not specified even though the parameter is an
axis–type while loading parameters or pitch error compensation data
from a tape or by entry of the G10 parameter.
Or, data No. address N, or setting data address P or R are not specified.
PS0302 ILLEGAL DATA NUMBER A non–existent data No. was found while loading parameters or pitch
error compensation data from a tape or by entry of the G10 parameter.
This alarm is also generated when illegal word values are found.
An invalid address R value is specified in a pattern program for each
machining purpose on the high–speed high–precision setting screen.
PS0303 ILLEGAL AXIS NUMBER An axis No. address exceeding the maximum number of controlled axes
was found while loading parameters from a tape or by entry of the G10
parameter.
PS0304 TOO MANY DIGIT Data with too many digits was found while loading parameters or pitch
error compensation data from a tape.
PS0305 DATA OUT OF RANGE Out–of–range data was found while loading parameters or pitch error
compensation data from a tape.
The values of the data setting addresses corresponding to L Nos. during
data input by G10 was out of range.
This alarm is also generated when NC programming words contain
out–of–range values.
PS0306 MISSING AXIS NUMBER A parameter which requires an axis to be specified was found without an
axis No. (address A) while loading parameters from a tape.
PS0307 ILLEGAL USE OF MINUS SIGN Data with an illegal sign was found while loading parameters or pitch
error compensation data from a tape, or by entry of the G10 parameter.
A sign was specified to an address that does not support the use of
signs.
PS0308 MISSING DATA An address not followed by a numeric value was found while loading
parameters or pitch error compensation data from a tape.
PS0330 ILLEGAL SPINDLE NUMBER An spindle No. address exceeding the maximum number of controlled
spindles was found while loading parameters from a tape or by entry of
the G10 parameter.
PS0332 DATA WRITE LOCK ERROR Could not load data while loading parameters, pitch error compensation
data and work coordinate data from tape.
PS0333 DATA WRITE ERROR Could not write data while loading data from tape.
PS0360 PARAMETER OUT OF RANGE (TLAC) Illegal parameter setting. (Set value is out of range.)