
Index
B–63785EN/01
i–1
[Symbols]
αi Servo Information Screen, 104
αi Spindle Information Screen, 107
αi Spindle Status Error Display, 111
[Numbers]
15i series hardware, 113
[A]
AC spindles, 344
Addresses, 287
Adjustment, 195
Alarm list, 452
Alarm OT0032 (reference position return request),
390
Alarm PS200 (grid synchronization error), 388
Alarm related to spindle control, 392
Alarm screen (ALARM), 296
Alarm SO0225 (serial spindle CRC error), 393
Alarm SP0201 (duplicate definition of spindle motor
number), 392
Alarm SP0202 (invalid spindle selection), 392
Alarm SP0220 (no spindle amplifier), 392
Alarm SP0221 (illegal spindle motor number), 392
Alarm SP0226 (serial spindle framing error), 393
Alarm SP0227 (serial spindle reception error), 393
Alarm SP0228 (serial spindle communication error),
393
Alarm SP0229 (communication error between serial
spindle and spindle amplifier), 393
Alarm SP0230 (spindle motor number outside allow-
able range), 393
Alarm SP0241 (abnormal D/A converter, 394
Alarm SP0975 (analog spindle control error), 394
Alarm SP0976 (serial spindle communication control
error), 394
Alarm SP0978 (serial spindle communication control
error), 394
Alarm SP0979 (serial spindle communication control
error), 394
Alarm SP0980 (serial spindle amplifier error), 395
Alarm SP0981 (serial spindle amplifier error), 395
Alarm SP0982 (serial spindle amplifier error), 395
Alarm SP0983 (serial spindle amplifier error), 395
Alarm SP0984 (serial spindle amplifier error), 395
Alarm SP0985 (serial spindle control error), 395
Alarm SP0987 (serial spindle control error), 395
Alarm SP0996 (illegal spindle parameter setting), 392
Alarm SV027 (invalid digital servo parameter), 391
Alarms SR820 to SR854 (reader/punch interface
alarms), 382
Analog interface AC spindle, 358
Automatic operation is impossible, 374
Automatic operation start signal turned off, 380
Automatic setting of standard parameters, 357
[B]
Background edit alarm, 468
Basic unit, 155
BIOS Diagnostic Message, 103
BIOS SET–UP of CNC Display Unit with PC Func-
tions, 101
Boot system, 429
Both manual and automatic operations are impossible,
363
Built–in debugging functions, 287
[C]
Cable clamping and shielding, 227
Chapter selection keys, 5
Checking the I/O Link allocation, 421
Checking whether hardware links have been estab-
lished, 420
CNC Display Unit with PC Functions, 191
CNC display unit with PC functions, 157
CNC Display Unit with PC Functions Maintenance
Equipment, 166
CNC state indications, 24
Communication setting screen, 232
Configuration of the PCB, 194
Connection for one unit, 125
Connection for two units (10.4”), 127
Connector locations and card configuration for each
printed circuit board, 117
Continuous data entry, 298
Control unit grounding, 225
Counter screen (COUNTR), 299
Countermeasures against noise, 222