
1. GENERAL
B–61863E/15
STEP SEQUENCE FUNCTION
970
[ ]
Step A
Transition B
Starts execution. Waits for machining request.
(Process 1)
Machining request?
±When machining is requested
Step C
Transition D
Loading completed?
±Once loading has been completed
Step E
Transition F Machining completed?
±Once machining has been completed
Step G
Transition H Unloading completed?
±Once unloading has been completed
Step I
Holds a workpiece on the pallet.
(Process 2)
Machines the workpiece. (Process 3)
Unloads the workpiece to the pallet.
(Process 4)
Moves the pallet. (Process 5)
Fig. 1.1 (d) Example of machining the workpiece
As shown in this example, the program flow from process 1 through
process 5 is expressed visually. Detailed programs related to the
movements performed aspart of each process, and the signals used for
determining whether transition conditions for proceeding to the next step
are satisfied, are not described here. To program complicated control
flows, many other functions are supported, such as divergence, jump, and
nesting functions. The details of these functions are described later.
Step sequence programming is suitable for creating programs which
control processes sequentially. Programs used for controlling a unit
which operates according to a certain sequence, such as a loader, ATC, and
other peripheral units, are best suited to step sequence programming. For
programs which control units with no particular sequence, such as that of
the operator’s panel which is always monitoring the emergency stop
signal or mode signals, however, are not well-suited to step sequence
programming. The PMC supports the advantages of both methods, ladder
and step sequence programming, by calling subprograms written
according to a step sequence and those written as a ladder, from the main
program.