
5. EDITING OF SEQUENCE
PROGRAM (EDIT)
B–61863E/15
PMC PROGRAMMER (CRT/MDI)
554
Refer to Fig. 5.5 (a) and Fig. 5.5 (b). Display the screen shown in Fig. 5.5
(b).
1 Display a number to set a message data by using PAGE key.
2 Shift the cursor to this number by the cursor key.
3 After setting message data, press INPUT key.
If the message data has already been entered, it is deleted and the set
data is entered.
Repeat steps 1 to 3 hereafter.
(1) Specify an address to be searched for, and press the [SRCH] soft key.
Then, the specified address is searched for and displayed on the
screen.
Edit modes can be changed by pressing the [INPMOD] soft key as
follows:
Maximum char-
acter input (32
characters)
Insertion input
(INSERT)
Replacement input
(ALTER)
Character string edit status
The edit mode is changed every time the [INPMOD] soft key is pressed.
[INSERT] is displayed on the screen in the insertion mode.
[ALTER] is displayed on the screen in the replacement mode.
D When the <INPUT> key is pressed
(1) In the character string edit status
Insertion mode : The entered character is inserted at the cursor.
Replacement mode : The character at the cursor is replaced with
the entered character.
(2) When the maximum number of characters are entered
The original character string at the cursor is replaced with the
entered characters.
D When the <DELETE> key is pressed
(1) In the character string edit status
Insertion mode : The character at the cursor is deleted.
Replacement mode : The character at the cursor is replaced with
a space.
(2) When the maximum number of characters are entered
The character string at the cursor is deleted.
(3) When the cursor is located at the address field
The entire message data specified at the address is deleted.
5.5.1
Message Data Input
5.5.2
Searching for an
Address (SRCH)
5.5.3
Editing a Character
String in Message Data