
B–61863E/15
2. SETTING FUNCTION
FS16i/18i/21i/0i–B PMC–SA1/SB7 MANIPULATION
859
D HIDE PMC PROGRAM
(PMC–SB7: K900.0, PMC–SA1: K17.0) ”NO”
D EDIT ENABLE
(PMC–SB7: K901.6, PMC–SA1: K18.6) ”YES”
D ALLOW PMC STOP
(PMC–SB7: K902.2, PMC–SA1: K19.2) ”YES”
NOTE
Please use the password function of sequence program for
particular operator. Please refer to FANUC LADDER–III
operator’s manual B–66234EN ”5.4 PROTECING LADDER
PROGRAMS BY PASSWORD”.
WARNING
If a sequence program is stopped while the machine is
operating, the machine may behave unexpectedly. Before
stopping the sequence program, make sure that nobody is
near the machine and that the tool cannot interfere with the
work–piece or machine. Incorrect operation of the machine
presents an extreme risk of death or serious injury to the
user. Damage the tool, work–piece, and/or the machine is
also likely.
v) The case that operator who familiar with the machine and the ladder
sequence operate all the PMC programmer functions;
D PROGRAMMER ENABLE
(PMC–SB7: K900.1, PMC–SA1: K17.1) ”YES”
D HIDE PMC PROGRAM
(PMC–SB7: K900.0, PMC–SA1: K17.0) ”NO”
WARNING
If a sequence program is stopped while the machine is
operating, the machine may behave unexpectedly. Before
stopping the sequence program, make sure that nobody is
near the machine and that the tool cannot interfere with the
work–piece or machine. Incorrect operation of the machine
presents an extreme risk of death or serious injury to the
user. Damage the tool, work–piece, and/or the machine is
also likely.