
B–61863E/15
4. OPERATIONPMC PROGRAMMER (SYSTEM P series)
1099
Example)
Key in ’L1
, 100 NL’
Output end liner number (If this parameter is
omitted, data are output to the last one.)
Output start line number
(5) OUTPUT MESSAGE DATA
Message data are output to a device specified by an F key.
Turn on an F key corresponding to a device to be output, and key in
detail menu number ’05 <NL>’.
The screen is switched and the following display appears.
OUTPUT = ’A@@.@ (,@@.@)’
OUTPUT =_
Specify the output range by addresses as follows.
Example)
Key in ’A1.0
,10.1’
Output end address (If this parameter is
omitted, data are output to the last one.)
Output start address
(6) OUTPUT I/O MODULE DATA
I/O module data are output to a device specified by an F key.
Turn on an F key corresponding to a device to be output, and key in
detail menu number ’06 <NL>’.
(7) OUTPUT LADDER PROGRAM (MNEMONIC)
Ladder program (source format) data are output to a device specified
by an F key.
Turn on an F key corresponding to a device to be output, and key in
detail menu number ’07 <NL>’.
The screen is switched and the following display appears.
OUTPUT = ’L@@@@ (,@@@@)’
OUTPUT =_
Specify the output range by line numbers as follows.
Example)
Key in ’L1
,100 NL’
Output end line number (If this parameter is
omitted, data are output to the last one.)
Output start line number
(8) OUTPUT LADDER DIAGRAM (ONLY FANUC PRINTER)
A ladder diagram is output to the FANUC printer (external printer).
Key in detail menu number ’08 <NL>’, and then, turn on F10 key.
Turn on F13 key furthermore, if it is desired to output the ladder
diagram with a cross reference.
The screen is switched and the following display appears.
OUTPUT = ’L@@@@ (,@@@@)’
OUTPUT =_
Specify the output range by line numbers as follows.
(Partial output is also possible.)