
B–61863E/15
3. LADDER DIAGRAM
MONITOR (PMC–SB7)
FS16i/18i/21i/0i–B PMC–SA1/SB7 MANIPULATION
865
These screens can be reached as described bellow.
PMC Main Menu
[PMCLAD][<]
[EDIT][<]
Ladder Diagram
Editor screen
Program List
Editor screen
[LIST]
[ZOOM], [<]
Net Editor screen
[CREATE], [MODIFY][<]
Editor
Function
Monitor
Function
NOTE 1
Ladder Diagram
Monitor screen
Program List
Viewer screen
Collective Monitor
screen
[SWITCH]
[SWITCH]
[ZOOM][LIST][ZOOM][LIST]
[LIST]
[ZOOM]
[ZOOM]
[BACK]
Step Sequence
Monitor screen
Fig. 3 Relation of monitor and editor screen
NOTE
1 When [PMCLAD] soft key is pressed, the screen which was displayed last time among Ladder
Diagram Monitor screen, Collective Monitor screen Step Sequence Monitor screen and
Program List Viewer screen is displayed. When [PMCLAD] soft key is pressed at first time after
CNC power is on, Program List Viewer screen is displayed. Changing the ladder program by
I/O function will also make Program List Viewer screen appears at [PMCLAD] soft key again.
See ”Program List Viewer screen” for more detail.
2 [EDIT] soft key in Ladder Diagram Monitor screen appears only when Programmer function is
enabled. To enable Programmer function, set ”PROGRAMMER ENABLE” to ”YES” at
GENERAL screen of PMC Settings or set keep relay K900.1 to 1. Or, set ”EDIT ENABLE” to
”YES” or set K901.6 to 1. While Online Monitor function is active, you can not reach Ladder
Diagram Editor screen. To use Ladder Diagram Editor function, you have to disable Online
Monitor function at ”RS–232C” and ”F–BUS” on ”PARAMETERS FOR ONLINE MONITOR”:
choose ”NOT USE”.
3 Refer to ”VI. STEP SEQUENCE FUNCTION” of ”7. OPERATION (PMC–SB7)” for the Step
Sequence Monitor screen in the figure.