
7. WRITING, READING, AND VERIFYING
THE SEQUENCE PROGRAM AND
PMC PARAMETER DATA
B–61863E/15
PMC PROGRAMMER (CRT/MDI)
582
CAUTION
If DATA ERROR is displayed when a C program is written
with the Series 16i/18i, perform the following:
1 Clear the C language area by pressing soft keys [EDIT],
[CLEAR], [CLRLNG], then [EXEC].
2 Read the C program again.
3 On the system parameter screen, set LANGUAGE
ORIGIN.
4 Write the C program into FLASH ROM.
(e) Collating data
Item Operation
DEVICE Press the [OTHERS] soft key.
FUNCTION Press the [COMPAR] soft key.
Press the [EXEC] soft key and wait until data collation finishes.
The input/output device starts outputting data.
NOTE
PMC data cannot be collated. The data the file is to be
collated with depends on the file.
Ę : Supported
: Not supported
Power
Mate
FS20
FS21/
210MB
FS18 FS16 FS18B FS16B
FS16–C
FS18–C
FS21i
FS16i
FS18i
FS15B
Ę Ę Ę Ę Ę Ę Ę Ę Ę Ę
PMC SPEED OTHERS MONIT STOP
BAUD RATE = 3
(0:1200,1:2400,2:4800,3:9600,4:19200)
PARITY BIT = 0
(0:NONE,1:ODD,2:EVEN)
STOP BIT = 1
(0:1BIT,1:2BIT)
WRITE CODE = 1
(0:ASCII,1:ISO)
>
ALM
[INPUT ] [ ] [ ] [ ] [ INIT ]
7.3.6
Setting the Transfer
Speed ([SPEED] Soft
Key)