
3. DISPLAYING PMC INPUT/OUTPUT
SIGNALS AND INTERNAL RELAY
(PMCDGN)
B–61863E/15
PMC–NB6 MANIPULATION
678
The following setting is necessary to enable each mode.
In the GENERAL screen of PMC setting:
Set ”SIGNAL STATUS WRITE ENABLE” to ”YES”.
Or
Set ”PROGRAMMER ENABLE” to ”YES”.
In the GENERAL screen of PMC setting:
Set ”PROGRAMMER ENABLE” to ”YES”.
Or, In the EDIT/DEBUG screen of PMC setting:
Set ”OVERRIDE ENABLE” to ”YES”.
Then, turn on the power supply again.
CAUTION
1 Please disable the forced I/O function when the machine is
shipped.
2 The setting ”OVERRIDE ENABLE” is set to ”NO”
automatically and the override function becomes disabled
when the setting ”PROGRAM ENABLE” to ”NO” and turning
off the power supply.
3 The settings of the override mode are not kept after turning
off the power supply. All bits of X and Y are not in the
override mode just after turning on the power supply.
3.7.2
Operations to Enable
the Forced I/O
Function
3.7.2.1
Setting of forcing mode
3.7.2.2
Setting of override mode