
B–61863E/15
5. LADDER DIAGRAM EDITOR
FUNCTION (PMC–SB7)
FS16i/18i/21i/0i–B PMC–SA1/SB7 MANIPULATION
909
(a) Screen configuration
1. [
], [ ], [ ], [ ], [
s
], [
R
], Enter
and change relay
Place relays (contacts and coils), or change type of existing relays.
When one of these relay soft keys is pressed at cursor on blank
place, new relay of the soft key is placed under the cursor. When
the soft key follows a string that means a bit address, the bit address
is assigned to the newly placed relay. If no bit address is given, last
entered bit address is automatically used for the new relay. If no bit
address has been entered yet, the new relay will have no address
assigned to it. Contacts can be placed at other than rightmost
column, and coils can be placed at rightmost column only. Moving
cursor onto an existing relay, pressing a relay soft key of different
type changes the type of relay under the cursor. But, changing coil
to contact, and changing contact to coil are forbidden. It is basically
same with Ladder diagram Editor screen, except that only one net.
Sample of contacts and coils
2. [FUNC] Enter and change functional instruction
Places functional instruction, or changes type of existing
functional instruction. When [FUNC] soft key is pressed at cursor
on blank place, new functional instruction will be placed under the
cursor. List of available functional instructions is displayed, then
choose type of functional instruction to be entered. When [FUNC]
soft key follows a string that means number or name of a functional
instruction is entered directly, without the list screen. Moving
cursor onto an existing functional instruction, pressing [FUNC]
soft key changes the type of functional instruction under the cursor.
3. [
]Draw horizontal connection
Draws horizontal connection line. Or alters an existing relay to
horizontal line.
4. [
]Erase relays and functional instructions
Erases relays and functional instructions under cursor.
5. [
], [ ]Draw and erase vertical connection
Draw vertical connection line upward from right or left edge of
relay or horizontal line under cursor. Or erase existing vertical
lines. If the relay or line under the cursor has no vertical line
upward, these soft keys have solid arrows, and indicate that
pressing them means drawing lines. On the other hand, if a vertical
line already exists under the cursor, arrows in these soft keys
become pale ([
], [ ]), and indicate that pressing them
means erasing lines.