
3. DISPLAYING PMC INPUT/OUTPUT
SIGNALS AND INTERNAL RELAY
(PMCDGN)
B–61863E/15
PMC–NB6 MANIPULATION
652
On the trace screen, you can trace specified signals. The result of the trace
is displayed as the time chart of signals.
There are two tracing modes. One is the ”Time Cycle” mode that samples
the state of the signals at every specified cycle time. The other is the
”Signal Transition” mode that samples the status of the signals when the
signals that are watched at every specified time are changed.
Pushing [TRACE] soft key displays the following screen.
To execute tracing, setting of the trace parameter is necessary. Pushing the
[SETING] soft key displays ”Parameter Setting” screen. The trace
function is able to run automatically by the setting on ”PMC Setting”
screen when the power is switched on. In this case, setting of the trace
parameter is necessary in advance.
NOTE
As for the setting of automatic running for the trace function,
please refer to ”IV–5.1 Screen for Displaying General
Settings (GENERAL)”
3.5
TRACE SCREEN
3.5.1
Overview