
B–61863E/15
4. OPERATIONPMC PROGRAMMER (SYSTEM P series)
1117
Search a sequence program by using the following soft keys.
(1) Soft key [TOP]
When this key is pressed, the start of the sequence program is
desplayed on the screen and the cursor also sifts to the program start
position.
(2) Soft key [BOTTOM]
When this key is pressed, the last of the sequence program is
displayed on the screen and the cursor also shifts to this program end
position.
(3) Soft key [SRCH]
In this search, you specify an address you want to search and it
searches the specified address from the program of the cursor part on
this screen to the last part of the program and displays the address on
the screen. There are two methods to specify the address you want
to search.
(a) Method of specifying the address by the cursor
Set the cursor to the relay contact part of the address you want to
search and press the soft key [SRCH].
The system searches the same address as the address specified by
the cursor from the cursor part of the program currently displayed
on the screen to the end of the program.
When the same address is found, the program part is displayed
on the screen, and the cursor shifts to that address part. If the same
address is not found as a result of this search, the cursor remains
in the same position.
When finishing, press the soft key on the extreme left.
(b) Method of specifying the address by input
Input the address you want to searcch by using address and
numeric keys, then press the soft key [SRCH].
The same address as specified is searched from the program of the
cursor part currently displayed on the screen to the last part of the
program.
When the same address is found, the program part is displayed
on the screen, and the cursor shifts to that address part.
If the same address is not found as a result of this search, an error
is displayed.
(4) Soft key [W–SRCH]
This key specifies an address of the relay coil to be searched, and then
searches the relay coil of the specified address from the program at
the cursor part to the end of the program on this screen. Then, it
displays the relay coil on the screen.
Two methods are available to specify the address of the relay coil to
be searched.
(a) Method of specifying the address by cursor
Set the cursor to the relay contact of the relay coil to be searched,
and press the soft key [W–SRCH].
The corresponding relay coil is searched from the program of the
cursor part to the end of the program.
When the relay coil is found, the program part is displayed on the
screen, and the cursor shifts to the relay coil.
4.9.8
Searching a Sequence
Program