
4. OPERATION
B–61863E/15
PMC PROGRAMMER (SYSTEM P series)
1116
If the [INSELM] key is pressed with the cursor in the position on
the left, the state shown in the diagram on the right will occur.
Cursor
b
a
If the character ”A” is keyed in and the [INSELM] key is pressed
with the cursor in the position on the left, the state shown in the
diagram on the right will occur.
(1) For deleting part of a program, use the following three kinds of soft
keys and delete after setting the cursor to the unnecessary part.
[– – – –] : Deletion of horizontal lines, relay contacts coils, etc.
[
] : Deletion of upper left vertical line to the cursor
[
] : Deletion of upper right vertical line to the cursor
(2) For the deletion of a program net (part corresponding to the section
from RD instruction to WRT instruction), use the [DELNET] key.
(3) Deleting multiple NETs in NET units
SEARCHDELNET ADRESSINSERTINSNET MOVECOPY
EXEC CANCEL SEARCH C–DOWN C–UP
1 Deletion
Move the cursor to the NET you want to delete and press the
[DELETE] key. The net you want to delete will be displayed in
red. (In the case of Mate, in reversal display.)
2 Deleting multiple nets
Move the cursor with the cursor DOWN key, [C–DOWN] key, or
[SEARCH] key to display in red the NET you want to delete. (In
the case of Mate, in reversal display.) Further, key in a numerical
value and press the [C–DOWN] key to move the cursor the
number of times specified by this value.
3 Execution Press the [EXEC] key. . . . . .
Cancellation Press the [CANCEL] key. . . .
4 If you already know the NET you want to delete, move the cursor
to the first NET, key in the number of NETs, and press the
[DELNET] key to omit steps 1 and 2.
4.9.7
Deleting a Sequence
Program