
4. OPERATION
B–61863E/15
PMC PROGRAMMER (SYSTEM P series)
1096
SELECT THE TYPE OF ROM MODULE ACCORDING
TO THE FOLLOWING NO.
ROM MODULE 0:A 1:B, 2:C, 3:D
NO.=
By means of the above–described operations, the program
transfer is started. The transfer screen is displayed on the
SYSTEM P Series screen and the transfer counter counts. The
screen returns to the menu screen after the end of transfer.
(2) Input from a floppy disk
1 Turn on the F2 key. (Turn on the F12 key at the same time when
the C language program is included.)
2 If the menu number ‘3 [NL]’ is keyed in, the message shown
below will be displayed. PMC–SA1/SA2/SB is not displayed.
Key in the type of ROM module to be used from now on. (Refer
to Note 1 when selecting ROM module B, C or D.)
SELECT THE TYPE OF ROM MODULE ACCORDING
TO THE FOLLOWING NO.
ROM MODULE 0:A 1:B, 2:C, 3:D
NO.=
3 The following message is displayed at the lower left part of the
screen.
SET FD & KEY IN ‘OK’,‘KILL’ OR ‘NO’
FD=OK <@FILE NAME>
FD0=OK <DRIVE><@NAME OR : NUMBER>
FD0=
4 Insert the floppy into the disk and enter the following data
5 ’OK @LADDER2
[NL]
File name
6 The screen is switched and the ROM format program is started
from the floppy disk.
7 After reading is ended, the screen is automatically changed to the
program menu screen if no problem occurs. When an error is
detected during reading, ’PART’ = is displayed on the left lower
part of the screen. Check the error and key in ’E [NL]’ to return
the screen to the program menu screen.
(3) Method of inputting from the FA writer and PMC writer
1 Check the setting of the ROM writer. (See Section 3.4, ”Setting
of I/O Device.”)
2 Put the FA Writer in the REMOTE mode by the
[REMOTE/LOCAL] key before using it.
3 Turn on the F9 key. (Turn on the F12 key at the same time when
the C language program is included.)
4 If the menu number ‘3 <NL>’ is keyed in, the message shown
below will be displayed. PMC–SA1/SA2/SB/SC is not
displayed. Key in the type of ROM module to be used from now
on. (Refer to Note 1 when selecting ROM module B, C or D.)
SELECT THE TYPE OF ROM MODULE ACCORDING
TO THE FOLLOWING NO.
ROM MODULE 0:A 1:B, 2:C, 3:D
NO.=