
4. DESCRIPTION OF PARAMETERS
B–63610EN/01
180
NOTE
These parameters are used for the multi–spindle control.
3820
Data for adjusting the gain of the analog output of the third–spindle speed
[Data type] Word
[Unit of data] 0.1%
[Valid data range] 700 to 1250
Set the data used for adjusting the gain of the analog output of the third
spindle speed.
NOTE
This parameter is used for controlling the multi–spindles.
3821
Offset–voltage compensation value of the analog output of the third–spindle speed
[Data type] Word
[Unit of data] Velo
[Valid data range] –1024 to 1024
Set the offset–voltage compensation value of the analog output of the
third–spindle speed.
NOTE
This parameter is used for controlling the multi–spindles.
3822
Maximum speed of the third spindle
[Data type] Word
[Unit of data] min
–1
[Valid data range] 0 to 32767
This parameter sets the maximum speed for the third spindle.
When a command specifying a speed exceeding the maximum spindle
speed is specified, or the spindle speed exceeds the maximum speed
because of the spindle speed override function, the spindle speed is
clamped at the maximum speed set in the parameter.