
B–63610EN/01
4. DESCRIPTION OF PARAMETERS
331
DSL If the selection of an axis is changed when PMC axis selection is disabled:
0 : P/S alarm No.139 is issued.
1 : The change is valid, and no alarm is issued for an unspecified system.
NCI In axis control by the PMC, a position check at the time of deceleration is:
0 : Performed.
1 : Not performed.
NDI For PMC axis control, when diameter programming is specified for a
PMC–controlled axis:
0 : The amount of travel and feedrate are each specified with a radius.
1 : The amount of travel and feedrate are each specified with a diameter.
NOTE
NDI is valid for an axis for which diameter programming is
specified (bit 3 (DIAx) of parameter No. 1006 is set to 1)
when bit 1 (CDI) of parameter No. 8005 is set to 0.
#7
MFD8005
#6 #5
IFV
#4 #3
DRR
#2
R10
#1
CDI
#0
EDC
[Data type] Bit
EDC In PMC–based axis control, an external deceleration signal is:
0 : Disabled.
1 : Enabled.
CDI For PMC axis control, when diameter programming is specified for a
PMC–controlled axis:
0 : The amount of travel and feedrate are each specified with a radius.
1 : The amount of travel is specified with a diameter while the feedrate is
specified with a radius.
NOTE
1 This parameter is valid when bit 3 (DIA) of parameter
No.1006 is set to 1.
2 When CDI is set to 1, bit 7 (NDI) of parameter No.8004 is
disabled.
R10 When the RPD parameter (bit 0 of parameter No.8002) is set to 1, the unit
for specifying a rapid traverse rate for the PMC axis is:
0 : 1 mm/min.
1 : 10 mm/min.
DRR For cutting feed per rotation in PMC axis control, the dry run function is:
0 : Disabled.
1 : Enabled.
IFV Override for each group in PMC axis control is:
0 : Disabled.
1 : Enabled.
MFD Output by each auxiliary function of the PMC axis control function is:
0 : Disabled.
1 : Enabled.