
B–63610EN/01
4. DESCRIPTION OF PARAMETERS
47
#7
1202
#6 #5 #4
G52
#3
RLC
RLC
#2
G50
#1
EWS
#0
EWD
[Data type] Bit
EWD The shift direction of the workpiece coordinate system is:
0 : The direction specified by the external workpiece zero point offset
value
1 : In the opposite direction to that specified by the external workpiece
zero point offset value
EWD=0
EXOFS : External workpiece zero point offset value
(Shifted workpiece
coordinate system)
X
EXOFS
XXX
Z
Z
Z
Z
–EXOFS
EWD=1
(Original workpiece
coordinate system)
EWS Shift value of the workpiece coordinate system and external workpiece
zero point offset value are
0 : Stored in the separate memory areas.
1 : Stored in the same memory area, that is, the shift and the offset values
are the same.
G50 When the CNC has commands G54 to G59 specifying workpiece
coordinate systems (optional function), if the G50 command for setting a
coordinate system (or the G92 command in G command system B or C) is
specified,
0 : G50 is executed and no alarm is issued.
1 : G50 is not executed and a P/S alarm (No. 010) is issued.
RLC Local coordinate system is
0 : Not cancelled by reset
1 : Cancelled by reset
G52 In local coordinate system setting (G52), a cutter compensation vector is:
0 : Not considered.
1 : Considered.
NOTE
Select a local coordinate system setting operation when
cutter compensation is applied, and when two or more
blocks specifying no movement exist prior to the
specification of G52, or when G52 is specified after cutter
compensation mode is canceled without eliminating the
offset vector.