
B–63610EN/01
4. DESCRIPTION OF PARAMETERS
181
NOTE
1 This parameter is valid when the multi–spindle control option
is selected.
2 When the constant surface speed control option is selected,
the spindle speed is clamped at the specified maximum
speed, regardless of whether the G96 mode or G97 mode
is set.
3 When 0 is set in this parameter, the setting of parameter
No.3772 for the first spindle is used. When 0 is set in
parameter No.3772, the spindle speed is not clamped.
4 When spindle speed command control is applied using the
PMC, this parameter has no effect, and the speed of the
spindle is not clamped.
3831
Maximum spindle speed for gear 1 of the third spindle
3832
Maximum spindle speed for gear 2 of the third spindle
[Data type] Word
[Unit of data] min
–1
[Valid data range] 0 to 32767
Set the maximum spindle speed for each gear of the third spindle.
NOTE
These parameters are used for the multi–spindle control.