
12. DETECTORS FOR THE SPINDLE
B–65162E/03
542
(a) Method of connection
There are two methods of connecting an α position coder or
high–resolution position coder with the spindle.
(1) Connecting a position coder to the back of the spindle with a flexible
joint
This method conveys the rotation of the spindle precisely to the
position coder, so that the positioning precision of the position coder
is high. However, this method imposes a restriction on the location
of the installation. So, some modifications to the mechanical section
may become necessary.
(2) As shown below, fit the shaft for holding the pulley onto the shaft of
the position coder, and hold the shaft with double bearings. Thus, the
pulley of the position coder is connected to the pulley mounted on the
spindle via a timing belt.
α position coder or high–
resolution position coder
Key
Bearing
Pulley
Shaft
Mounting plate
Key
This connection method is generally used to connect a conventional
position coder to the spindle. When using this method, note the points
below.
1) If there is any play between the shaft for holding the pulley and the
shaft of the position coder, fretting can occur on the position coder
shaft, and the key can become loose, thus resulting in degraded
precision of the position coder positioning. So, fit the components
together accurately to ensure that there is no play between the position
coder shaft and shaft holding the pulley, or between the key and key
groove.
2) If the axis center of the position coder shaft is not aligned with the axis
center of the circumference of the position coder pulley, or if the axis
center of the spindle is not aligned with the axis center of the pulley
fitted onto the spindle, the positioning precision of the spindle
degrades in proportion to the magnitude of the eccentricity. So,
minimize these eccentricities.
12.1.3
Mounting Conditions
and Notes