B-64120EN/01 2.SETTING PARAMETERS FROM MDI
- 3 -
2 SETTING PARAMETERS FROM MDI
Follow the procedure below to set parameters.
(1) Place the NC in the MDI mode or the emergency stop state.
(2) Follow the substeps below to enable writing of parameters.
1. To display the setting screen, press the
function key
as many times as required, or alternatively press the
function key once, then the [SETTING] section select soft
key. The first page of the setting screen appears.
2. Position the cursor on "PARAMETER WRITE" using the
cursor move keys.
3. Press the [(OPRT)] soft key to display operation select soft
keys.
4. To set "PARAMETER WRITE=" to 1, press the ON:1 soft
key, or alternatively enter 1 and press the INPUT soft key.
From now on, the parameters can be set. At the same time
an alarm condition (P/S100 PARAMETER WRITE
ENABLE) occurs in the CNC.
(3) To display the parameter screen, press the
function key as
many times as required, or alternatively press the
function
key once, then the PARAM section select soft key.
(See "1. Displaying Parameters.")
(4) Display the page containing the parameter you want to set, and
position the cursor on the parameter. (See "1. Displaying
Parameters.")
(5) Enter data, then press the [INPUT] soft key. The parameter
indicated by the cursor is set to the entered data.